Initial commit

1 files changed, 60 insertions, 0 deletions

diff --git a/Marlin/src/gcode/control/M226.cpp b/Marlin/src/gcode/control/M226.cpp
new file mode 100644
index 0000000..63f022e
--- /dev/null
+++ b/Marlin/src/gcode/control/M226.cpp
@@ -0,0 +1,60 @@
+/**
+ * Marlin 3D Printer Firmware
+ * Copyright (c) 2020 MarlinFirmware [https://github.com/MarlinFirmware/Marlin]
+ *
+ * Based on Sprinter and grbl.
+ * Copyright (c) 2011 Camiel Gubbels / Erik van der Zalm
+ *
+ * This program is free software: you can redistribute it and/or modify
+ * it under the terms of the GNU General Public License as published by
+ * the Free Software Foundation, either version 3 of the License, or
+ * (at your option) any later version.
+ *
+ * This program is distributed in the hope that it will be useful,
+ * but WITHOUT ANY WARRANTY; without even the implied warranty of
+ * MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE.  See the
+ * GNU General Public License for more details.
+ *
+ * You should have received a copy of the GNU General Public License
+ * along with this program.  If not, see <https://www.gnu.org/licenses/>.
+ *
+ */
+
+#include "../../inc/MarlinConfig.h"
+
+#if ENABLED(DIRECT_PIN_CONTROL)
+
+#include "../gcode.h"
+#include "../../MarlinCore.h" // for pin_is_protected and idle()
+#include "../../module/stepper.h"
+
+void protected_pin_err();
+
+/**
+ * M226: Wait until the specified pin reaches the state required (M226 P<pin> S<state>)
+ */
+void GcodeSuite::M226() {
+  if (parser.seen('P')) {
+    const int pin_number = PARSED_PIN_INDEX('P', 0),
+              pin_state = parser.intval('S', -1); // required pin state - default is inverted
+    const pin_t pin = GET_PIN_MAP_PIN(pin_number);
+
+    if (WITHIN(pin_state, -1, 1) && pin > -1) {
+      if (pin_is_protected(pin))
+        protected_pin_err();
+      else {
+        int target = LOW;
+        planner.synchronize();
+        pinMode(pin, INPUT);
+        switch (pin_state) {
+          case 1: target = HIGH; break;
+          case 0: target = LOW; break;
+          case -1: target = !extDigitalRead(pin); break;
+        }
+        while (int(extDigitalRead(pin)) != target) idle();
+      }
+    } // pin_state -1 0 1 && pin > -1
+  } // parser.seen('P')
+}
+
+#endif // DIRECT_PIN_CONTROL