blob: 26fb44f3980bb8988d56bee94b75d19a12772ee3 (
plain) (
blame)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
44
45
46
47
48
49
50
51
52
53
54
55
56
57
58
59
60
61
|
/**
* Marlin 3D Printer Firmware
* Copyright (c) 2020 MarlinFirmware [https://github.com/MarlinFirmware/Marlin]
*
* Based on Sprinter and grbl.
* Copyright (c) 2011 Camiel Gubbels / Erik van der Zalm
*
* This program is free software: you can redistribute it and/or modify
* it under the terms of the GNU General Public License as published by
* the Free Software Foundation, either version 3 of the License, or
* (at your option) any later version.
*
* This program is distributed in the hope that it will be useful,
* but WITHOUT ANY WARRANTY; without even the implied warranty of
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
* GNU General Public License for more details.
*
* You should have received a copy of the GNU General Public License
* along with this program. If not, see <https://www.gnu.org/licenses/>.
*
*/
#pragma once
/**
* Test Arduino Due specific configuration values for errors at compile-time.
*/
/**
* HARDWARE VS. SOFTWARE SPI COMPATIBILITY
*
* DUE selects hardware vs. software SPI depending on whether one of the hardware-controllable SDSS pins is in use.
*
* The hardware SPI controller doesn't allow software SPIs to control any shared pins.
*
* When DUE software SPI is used then Trinamic drivers must use the TMC softSPI.
*
* When DUE hardware SPI is used then a Trinamic driver can use either its hardware SPI or, if there are no shared
* pins, its software SPI.
*
* Usually the hardware SPI pins are only available to the LCD. This makes the DUE hard SPI used at the same time
* as the TMC2130 soft SPI the most common setup.
*/
#define _IS_HW_SPI(P) (defined(TMC_SW_##P) && (TMC_SW_##P == SD_MOSI_PIN || TMC_SW_##P == SD_MISO_PIN || TMC_SW_##P == SD_SCK_PIN))
#if ENABLED(SDSUPPORT) && HAS_DRIVER(TMC2130)
#if ENABLED(TMC_USE_SW_SPI)
#if DISABLED(DUE_SOFTWARE_SPI) && (_IS_HW_SPI(MOSI) || _IS_HW_SPI(MISO) || _IS_HW_SPI(SCK))
#error "DUE hardware SPI is required but is incompatible with TMC2130 software SPI. Either disable TMC_USE_SW_SPI or use separate pins for the two SPIs."
#endif
#elif ENABLED(DUE_SOFTWARE_SPI)
#error "DUE software SPI is required but is incompatible with TMC2130 hardware SPI. Enable TMC_USE_SW_SPI to fix."
#endif
#endif
#if ENABLED(FAST_PWM_FAN) || SPINDLE_LASER_FREQUENCY
#error "Features requiring Hardware PWM (FAST_PWM_FAN, SPINDLE_LASER_FREQUENCY) are not yet supported on DUE."
#endif
#if HAS_TMC_SW_SERIAL
#error "TMC220x Software Serial is not supported on this platform."
#endif
|
