blob: a55f5ca39f913b4e26e3fec29f523711ea8f8271 (
plain) (
blame)
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
34
35
36
37
38
39
40
41
42
43
|
/**
* Marlin 3D Printer Firmware
* Copyright (c) 2020 MarlinFirmware [https://github.com/MarlinFirmware/Marlin]
*
* Based on Sprinter and grbl.
* Copyright (c) 2011 Camiel Gubbels / Erik van der Zalm
*
* This program is free software: you can redistribute it and/or modify
* it under the terms of the GNU General Public License as published by
* the Free Software Foundation, either version 3 of the License, or
* (at your option) any later version.
*
* This program is distributed in the hope that it will be useful,
* but WITHOUT ANY WARRANTY; without even the implied warranty of
* MERCHANTABILITY or FITNESS FOR A PARTICULAR PURPOSE. See the
* GNU General Public License for more details.
*
* You should have received a copy of the GNU General Public License
* along with this program. If not, see <https://www.gnu.org/licenses/>.
*
*/
#include "../../inc/MarlinConfig.h"
#include "Delay.h"
void esp_wifi_init(void) { // init ESP01 WIFI module pins
#if PIN_EXISTS(ESP_WIFI_MODULE_GPIO0)
OUT_WRITE(ESP_WIFI_MODULE_GPIO0_PIN, HIGH);
#endif
#if PIN_EXISTS(ESP_WIFI_MODULE_GPIO2)
OUT_WRITE(ESP_WIFI_MODULE_GPIO2_PIN, HIGH);
#endif
#if PIN_EXISTS(ESP_WIFI_MODULE_RESET)
delay(1); // power up delay (0.1mS minimum)
OUT_WRITE(ESP_WIFI_MODULE_RESET_PIN, LOW);
delay(1);
OUT_WRITE(ESP_WIFI_MODULE_RESET_PIN, HIGH);
#endif
#if PIN_EXISTS(ESP_WIFI_MODULE_ENABLE)
delay(1); // delay after reset released (0.1mS minimum)
OUT_WRITE(ESP_WIFI_MODULE_ENABLE_PIN, HIGH);
#endif
}
|
